Threaded Mode | Linear Mode

**rprosperi** · (This post was last modified: 05-07-2023 12:57 AM by rprosperi.)

The instruction code for line 101 in both the 41X and V41 with PPC.MOD installed is the same, and correct, which is what appears in the 41 LCD to be '#' with a slash for the left vertical line, which is the 41C symbol for Not Equals; this opcode is Decimal 121, hex 79.

29 (not equals) and 35 (hash sign) are the CHARACTER bytes, not instructions, and you have to look closely, they are very similar. Use 29 XTOA 35 XTOA then Alpha to see them together in the display and note the differences.

Also, note that they may look alike when the 41X editor is in 4-line mode; press [DISP] until you have 10-line mode and you'll see the symbol in this instruction is the 'Not Equal' one

It appears the problem lies elsewhere...