HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Disassembly of HP-19C

Post Reply 
Disassembly of HP-19C
04-15-2021, 04:07 PM
Post: #21
Jonas Sandstedt Offline
Member
 		Posts: 101
Joined: Jun 2014
RE: Disassembly of HP-19C
I have an ERSA 60 analogue solder station with interchangeable tips, but only own one tip that I have used now and then during the years. Normally, there is no problem soldering and de-soldering, but these “bad” joints will not melt. Perhaps a new tip of chisel type will do the trick?
best regards
Jonas
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Disassembly of HP-19C - Jonas Sandstedt - 03-31-2021, 01:07 PM
RE: Disassembly of HP-19C - Don Williams - 03-31-2021, 02:06 PM
RE: Disassembly of HP-19C - Ren - 04-01-2021, 02:23 PM
RE: Disassembly of HP-19C - Don Williams - 04-01-2021, 02:49 PM
RE: Disassembly of HP-19C - Don Williams - 04-05-2021, 01:49 PM
RE: Disassembly of HP-19C - Don Williams - 04-05-2021, 05:04 PM
RE: Disassembly of HP-19C - [kby] - 04-08-2021, 10:06 PM
RE: Disassembly of HP-19C - teenix - 04-11-2021, 07:02 AM
RE: Disassembly of HP-19C - [kby] - 04-12-2021, 07:58 PM
RE: Disassembly of HP-19C - Jonas Sandstedt - 04-15-2021 04:07 PM
RE: Disassembly of HP-19C - [kby] - 04-17-2021, 01:41 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication