WANTED: 71B port covers
|
04-02-2021, 01:23 PM
Post: #5
|
|||
|
|||
RE: WANTED: 71B port covers
Nate Martin's 3D printed pieces are perfect, the problems if any, comes from Shapeways.
In this case, the little plastic piece that is keeping the port cover inside the 71B are not always printed correctly by Shapeways. This create the issue that sometime the port cover fall off. To address this little problem, I have put a small electric tape on the cover, this changes the depth a little but enough to create a small friction keeping the port cover in. Sylvain Pictures ... |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)