[BUG REPORT] Constants with exponents cause error

Threaded Mode | Linear Mode

[BUG REPORT] Constants with exponents cause error

06-04-2014, 07:47 PM (This post was last modified: 06-04-2014 07:48 PM by norlesh.)

Post: #1

norlesh Offline

Junior Member

Posts: 31
Joined: May 2014

[BUG REPORT] Constants with exponents cause error

From the CAS screen taking the square root of G or any other constant with an exponent causes a totally useless nondescript error message. If you edit the equation by deleting the E in the constant and replace it using the 'EEX' key then the same equation works....

This is in the newest firmware .... so not cool

« Next Oldest | Next Newest »

Messages In This Thread

[BUG REPORT] Constants with exponents cause error - norlesh - 06-04-2014 07:47 PM

RE: [BUG REPORT] Constants with exponents cause error - toml_12953 - 06-04-2014, 07:55 PM

RE: [BUG REPORT] Constants with exponents cause error - norlesh - 06-04-2014, 08:04 PM

RE: [BUG REPORT] Constants with exponents cause error - dbbotkin - 10-27-2014, 11:10 PM

RE: [BUG REPORT] Constants with exponents cause error - leonlenettoyeur - 10-28-2014, 03:07 AM

RE: [BUG REPORT] Constants with exponents cause error - dbbotkin - 10-28-2014, 04:59 AM

User(s) browsing this thread: 1 Guest(s)