New HP-41 Calculator Stand

[rprosperi]

(06-13-2020 09:36 PM)twoweims Wrote:  Ok. The modified model is up on Thingiverse:
https://www.thingiverse.com/thing:4439055

It is a bit longer so as to accommodate the position of the DM42/DM41X Feet.
It has recesses to match the feet of an HP-41, 67, Classic, Pioneer, and DM42/DM41X. I also modified it to print without supports.

Nice!!

Obviously much more flexible, the revised design of the lightening holes on the sides is more rakish, giving it a slightly meaner, more serious look, an improvement I appreciate.

I'm not real familiar with the 3D design and mfg. process; how can the portions suspended over air start to print with no integral supports?

I'll leave some feedback once I have some in use, but of course I can thank you now for this wonderful gift to the community.

A final question: AZGN ?

Thanks!