Battery options for 82143A printer

[Dave Britten]

(02-09-2020 12:03 AM)Paul Berger (Canada) Wrote:  Yeah 4/5 AA would work the space inside a shell for one of the battery packs for your printer is about 85mm, a quick way might be to get 4 single AA holder trim one end on them and glue them into the battery shell to form a pair of end to end 2 cell holders. You can even use the original contact but would nedd to either glue or tape them in place. My pack with AAA cells uses four single cell AAA holders fitted into a shell.

If I was better with 3D print design I might take a shot at designing something, but I am really only starting out.

Paul.

Ooh, that's a great idea, I hadn't considered cutting up AA holders and sticking them together. Even better, get a pair of 2 pc. AA holders and stick those end-to-end.

https://www.amazon.com/GFORTUN-Plastic-B...06XW891WK/

There's also a stacked 2x2 holder. I don't suppose that would fit in the battery compartment, would it?

https://www.amazon.com/WMYCONGCONG-Batte...07JMMCMBL/