Post Reply 
Introduction
01-28-2020, 11:04 PM
Post: #11
RE: Introduction
(01-28-2020 12:08 PM)wbvreeuwijk Wrote:  You've done some amazing work here, based on the above do you expect to be able to build another batch? and how big is this batch?
Also, other than needing the donor machine to be a fullnut HP41 with the right LCD drivers are there other things I should be aware of in search of a donor machine?

Thank you. Yes, I plan to do another batch of 50. Any fullnut will work, it's just a question of how much work will be required. As Sylvain said, there are suggestions in the manual for choosing a donor machine.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Introduction - wbvreeuwijk - 01-26-2020, 02:37 PM
RE: Introduction - Archilog - 01-26-2020, 08:38 PM
RE: Introduction - Massimo Gnerucci - 01-26-2020, 09:49 PM
RE: Introduction - David Hayden - 01-27-2020, 07:19 PM
RE: Introduction - Garth Wilson - 01-27-2020, 09:36 PM
RE: Introduction - Monte Dalrymple - 01-27-2020, 11:14 PM
RE: Introduction - wbvreeuwijk - 01-28-2020, 12:08 PM
RE: Introduction - Sylvain Cote - 01-28-2020, 01:14 PM
RE: Introduction - Monte Dalrymple - 01-28-2020 11:04 PM
RE: Introduction - wbvreeuwijk - 01-28-2020, 11:58 AM
RE: Introduction - grsbanks - 01-28-2020, 06:13 PM
RE: Introduction - MeindertKuipers - 01-29-2020, 07:12 PM
RE: Introduction - wbvreeuwijk - 01-31-2020, 11:39 PM



User(s) browsing this thread: 1 Guest(s)