HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Disappearing Key Assignments

Post Reply 
Disappearing Key Assignments
12-31-2019, 02:17 PM (This post was last modified: 12-31-2019 02:22 PM by twoweims.)
Post: #12
twoweims Offline
Senior Member
 		Posts: 307
Joined: Apr 2019
RE: Disappearing Key Assignments
Well, I think my initial fear has been verified.
I double checked the pinouts on my CableClub BC20213-6 Serial Cable. It is the correct cable.

clupdate starts and waits for 41CL Commands but CMOPEN on the CL results in COMM and then TIMEOUT.

I am in Turbo 50 mode.
I have executed SERINI and set the baud rate to 4800.

I will contact Monte about getting a new cable...
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Disappearing Key Assignments - twoweims - 12-30-2019, 03:27 PM
RE: Disappearing Key Assignments - twoweims - 12-31-2019 02:17 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication