[newRPL] interested in RPN mode?

[jpcuzzourt]

(11-22-2019 10:11 PM)JoJo1973 Wrote:  I think we'll just have to wait for Claudio to upload the code. When this happens, I'll be interested in your comments about the reformatted compile howto page: I cleaned it up a bit and reformatted it, but could have made some mistake with paths or filenames.

I'd like also to know if you find it clear and comprehensible!

Thanks!

(11-22-2019 10:41 PM)Claudio L. Wrote:  Usually these "unofficial" builds are not pushed to the Sourceforge repository until I'm sure of the stability and they undergo some more testing.
However, since you need it, I just did a push to sf for you. Go ahead and pull again.
Hopefully there's not too many bugs.

Thanks Claudio. It built a fresh new 1315 desktop version for me.
And JoJo, I think these are the same instructions I followed for the first time about a week or two ago, and I found them clear and helpful.

JP

EDIT: One thing that seems still-broken for me is the USB interface between the 39GS and newRPL-ui (64-bit Linux). Under version 1315, my 39GS does not appear in the USB device list.
I have followed the instructions for setting up udev rules and the "usbdevices" group. And I see the 39GS in lsusb output. Any tips or ideas that I can try at this point to troubleshoot?