HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / Units Question

Post Reply 
Units Question
07-16-2019, 10:18 PM (This post was last modified: 07-16-2019 10:22 PM by Gene222.)
Post: #1
Gene222 Offline
Member
 		Posts: 117
Joined: Feb 2015
Units Question
Is there a way I can test to see if a variable has a unit attached to it?

I was using x:=UVAL(x); where I wanted to strip away the units. If x=5_m, then UVAL returns 5. If x=5 without any units attached, then UVAL returns an error message and it stops my program. I wanted to test x to see if it had units before using the UVAL command.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Units Question - Gene222 - 07-16-2019 10:18 PM
RE: Units Question - roadrunner - 07-17-2019, 12:24 AM
RE: Units Question - Gene222 - 07-17-2019, 01:14 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication