HP 50g Double factorial
|
05-01-2019, 07:01 PM
Post: #13
|
|||
|
|||
RE: HP 50g Double factorial
(05-01-2019 06:26 PM)joeres Wrote: If I use very large numbers, the program runs in an infinite loop.I cannot confirm this behavior. If n!! is too large, I get MAXR, i.e. 9.99999999999E499. You must be using ZINTs, then. As a matter of fact, I wrote the code with an HP-48 in mind, so it is primarily intended for floats. (05-01-2019 06:26 PM)joeres Wrote: The other programs output the message "Integer too large".Again, this must be a ZINT-specific message. P.S. Thanks for reminding me of the missing "END", I just added it. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)