Post Reply 
41CL: Plugging a Module from RAM rather than FLASH?
11-03-2018, 03:41 PM
Post: #7
RE: 41CL: Plugging a Module from RAM rather than FLASH?
(11-03-2018 12:09 PM)burkhard Wrote:  
(11-03-2018 03:08 AM)Monte Dalrymple Wrote:  YIMP does not automatically engage 50x turbo mode.

Ahh, yes, I see now in the YNFX manual that Turbo50 is recommended for all serial operations. I didn’t do that when I updated the flash either, which now gives me some concern. So far, the CRCs of the modules I have checked all tested OK, but I wonder if there are messed up ones in there as well.

Should I reflash everything?
Or is there a way to CRC check the whole 0x000-0x3FF of flash memory in a single operation?

Thanks!

The various commands in YUPS automatically switch to 50x turbo when executing.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: 41CL: Plugging a Module from RAM rather than FLASH? - Monte Dalrymple - 11-03-2018 03:41 PM



User(s) browsing this thread: 1 Guest(s)