HP-01 Repair
|
03-20-2024, 06:20 PM
Post: #8
|
|||
|
|||
RE: HP-01 Repair
(03-20-2024 06:14 PM)Maximilian Hohmann Wrote:(03-20-2024 06:05 PM)blackjetrock Wrote: I'm wondering if it could be CNC'd out of a sheet of red acrylic if it's the front crystal or filter. Is that part flat or curved? If it is flat then a part could be machined, it might not even be necessary to polish it. All that is needed is a drawing or dimensions to at least 0.1mm |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HP-01 Repair - MLSist - 03-20-2024, 12:52 PM
RE: HP-01 Repair - floppy - 03-20-2024, 05:16 PM
RE: HP-01 Repair - KeithB - 03-20-2024, 05:49 PM
RE: HP-01 Repair - blackjetrock - 03-20-2024, 05:39 PM
RE: HP-01 Repair - Maximilian Hohmann - 03-20-2024, 05:54 PM
RE: HP-01 Repair - blackjetrock - 03-20-2024, 06:05 PM
RE: HP-01 Repair - Maximilian Hohmann - 03-20-2024, 06:14 PM
RE: HP-01 Repair - blackjetrock - 03-20-2024 06:20 PM
RE: HP-01 Repair - Maximilian Hohmann - 03-20-2024, 07:16 PM
|
User(s) browsing this thread: 1 Guest(s)