HP 67 slider switches and trace trouble

[teenix]

A somewhat awful soldering job.

Attached is the wiring for the 67 charge connector.

If you strip it all off and clean it up, careful with too much heat on the brass tube connectors. The plastic where they are fitted into may soften and the pins may move and won't align with the charger.

When re-assembling the middle plastic frame with the 6 screws, make sure it is seated properly. Sometimes it may not be and can warp when the screws are tightened.

The screws may have been in and out an unknown number of times, so when you tighten them, just nip them up, don't overdo it or the threads may strip.

cheers

Tony