Disassembly and Repair of the HP 82059B 41C Power Supply

[Hiwi]

Some hints about magwire:

Since I am a hamradio amateur I make often toroids for antennas and filters and i have to solder the magwires to e.g a PCB. Heating the wire up over 390 degrees (C) for about 10 s will burn any kind of enamel. It works very relaible. After burning, i clean the wire with aceton.

Usually tansformers are made with double coated enamel for security reasons, so keep this in mind, when you repair windings of a transformer or wind it completely new.

Ralf