HEPAX-0C Prototype version ROM images.

[KimH]

Steen,

I happen to visit in CPH this coming weekend, I could throw a (working) 9114 w/Good battery & Charger into the bag and drop by. If you're around - I'll drop you a PM.

(09-14-2020 08:20 PM)SteenPetersen Wrote:  I have a modified 9114 with a W&W Software Products GmbH power supply/battery modification. I plugged in the power supply - nothing - no red LED on the power supply. Opened it up and found the fuse to be toast. Easy to fix (short circuit), but still no red LED... Found my lab power supply - set it to 6 V and connected it (I checked the schematics (found on-line) on where to connect it) - no red LED on the 9114. Measured 6V on the output of the battery pack, so the 9114 is getting the right voltage - even with 3A available from the power supply.

Any suggestions on what to do next? - are there any loose connectors or fuses inside the 9114 which could cause this?

Thanks in advance
Steen

PS: Diego, I will likely accept your offer, but I will do a little more exploring in the "treasure chest" first.