Post Reply 
Bug with EDITMAT()
12-18-2014, 10:26 AM (This post was last modified: 12-18-2014 10:40 AM by bobkrohn.)
Post: #1
Bug with EDITMAT()
From Home. on actual calculator
EDITMAT() seems to work with built-in Matrix variables like M1.
Try to use a user defined Matrix and you discover a BUG.

Locks up the calculator.
on Reset you find your user defined Matrix has disappeared.

It seems to be OK on Emulator
Find all posts by this user
Quote this message in a reply
12-18-2014, 12:21 PM (This post was last modified: 12-18-2014 01:26 PM by Snorre.)
Post: #2
RE: Bug with EDITMAT()
Hi Bob,

I couldn't reproduce this behaviour on my device as couldn't reproduce the other bug you mentioned about digits in program/function names ("V4L1DN4M3" is a valid name) [EDIT: could reproduce the latter].

It seems that something's odd with your device. Have you already tried a hard reset (Turn off, then press and hold [Templ]+[Power]+[Comma], then switch on, then release, finally -- in diagnostic mode -- select [9] Reset). Beware, you'll wipe your data (make a backup).

[EDIT #2]: Forget about it! First check if your current app is "Spreadsheet" and if your matrix' name collides with a cell's name (maybe it's similiar to this issue).
Find all posts by this user
Quote this message in a reply
12-18-2014, 02:45 PM
Post: #3
RE: Bug with EDITMAT()
(12-18-2014 10:26 AM)bobkrohn Wrote:  From Home. on actual calculator
EDITMAT() seems to work with built-in Matrix variables like M1.
Try to use a user defined Matrix and you discover a BUG.

Locks up the calculator.
on Reset you find your user defined Matrix has disappeared.

It seems to be OK on Emulator

Is your firmware up to date?

Graph 3D | QPI | SolveSys
Find all posts by this user
Quote this message in a reply
12-19-2014, 05:28 AM
Post: #4
RE: Bug with EDITMAT()
Yes firmware it's up to date. Dec 03 2014 version.

Speadsheet is active but there is nothing in it.

I entered numeric data into M1 then Stored to my custom named variabe

i.e. M1>KoGo

I'll try everything again tomorrow.

Had to reset with a pin in the hole on back.
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 2 Guest(s)