HP Forum Archive 21

[ Return to Index | Top of Index ]

41CL and Card reader Message #1 Posted by Prabhu Bhooplapur on 16 Oct 2012, 5:35 a.m. I have configured my 41CL with a V.3 board. 41CL is initialised and a CAT2 shows card reader as a peripheral. CLUT rom is plugged in 1U. After launching the Hepax a CAT2 shows Hepax, CLUTIL-2H etc but not the card reader. How do I overcome this situation? Thanks.

Re: 41CL and Card reader Message #2 Posted by Monte Dalrymple on 16 Oct 2012, 5:11 p.m., in response to message #1 by Prabhu Bhooplapur It sounds as though you plugged something into page E, where the card reader resides. Perhaps some HEPAX RAM? This is not a good idea, as it will create a fight on the bus between the CL board and the card reader.

Re: 41CL and Card reader Message #3 Posted by Prabhu Bhooplapur on 18 Oct 2012, 3:34 a.m., in response to message #2 by Monte Dalrymple Hi Monte, Is there any way of configuring the 41CL to have both HEPAX and card reader access? Thanks. Prabhu

Re: 41CL and Card reader Message #4 Posted by Ángel Martin on 18 Oct 2012, 7:40 a.m., in response to message #3 by Prabhu Bhooplapur There are dozens of ways to do that. Just use ports/pages different from "E", which is reserved for the Card Reader. Bear in mind the HEPAX RAM has a variable number of pages. You can configure that using the HEPX4 (1x page), HEPX8 (2x pages), or HEPX16 (4-pages) functions of the POWERCL. Those pages are allocated sequentially, starting at the page# entered at the prompt - so take care that it doesn't reach "E". Note that the current mapping and content of those pages will be overwritten with HEPAX RAM *blank* templates (!) Once they're installed you can use HEPINI to actually configure the HEPAX File System, and assign XROM id# to the HEPAX RAM pages. Edited: 18 Oct 2012, 7:41 a.m.

[ Return to Index | Top of Index ]

Go back to the main exhibit hall