Post Reply 
[HP48] Display area flags
12-12-2014, 11:34 AM
Post: #1
[HP48] Display area flags
Hi all,

I'm studying how display area control works, and there is too much words that seems to do the same and confuse me,
so anyone could explain the different DA flags behaviors please, and when to use them ?

What is the difference between the commands (Set/Clr/?)DAValid and (Set/Clr/?)DABad ?
Same question for DATemp and DANoCh flags ? (Ok Temp is used to freeze the display, but why DANoCh exist ?)

What is the purpose for each of this flags ?

DAs flags and associated commands :
OK : Clr, ?
Bad : Set, Clr, ?
Valid : Set, Clr, ?
Temp : Set, Clr, ?
NoCh : Set, Clr, ?
Roll : Set, Clr, ?

Thanks
Find all posts by this user
Quote this message in a reply
12-14-2014, 05:47 PM
Post: #2
RE: [HP48] Display area flags
Hello Bruno,

Look at https://groups.google.com/forum/#!search...zcv9yX3AMJ.

Regards,

Mark
Find all posts by this user
Quote this message in a reply
12-15-2014, 09:47 PM
Post: #3
RE: [HP48] Display area flags
Check the rammap.a file within this archive:

http://www.hpcalc.org/details.php?id=3247

There is some explanation on the actual flags themselves.

Graph 3D | QPI | SolveSys
Find all posts by this user
Quote this message in a reply
12-16-2014, 08:31 AM
Post: #4
RE: [HP48] Display area flags
Ok, thanks for your help Han and Mark Smile
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: