Post Reply 
how to open *.DIR?
10-27-2021, 11:56 AM
Post: #1
how to open *.DIR?
from that one:
https://www.hpcalc.org/details/1059?


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
10-27-2021, 09:23 PM
Post: #2
RE: how to open *.DIR?
Just put DEMOS.DIR on the stack (level 1) of the HP48. Then enter: 'DEMO' STO.
Go to the DEMO directory (press VAR DEMO) and start the demos.
Find all posts by this user
Quote this message in a reply
10-28-2021, 07:04 AM
Post: #3
RE: how to open *.DIR?
yes, it works! thanks a lot
Find all posts by this user
Quote this message in a reply
10-31-2021, 11:49 AM
Post: #4
RE: how to open *.DIR?
one more question: how to open *.lib? Stack displays: Library<...>
Find all posts by this user
Quote this message in a reply
10-31-2021, 12:40 PM
Post: #5
RE: how to open *.DIR?
(10-31-2021 11:49 AM)dwesti Wrote:  one more question: how to open *.lib? Stack displays: Library<...>

Libraries can only be stored in Ports.

So, to store LIB123 in port-1, recall it to the stack and use:

:1:LIB123 STO

Note that any name can be used for the stored library.

Then, use [RS] [Library] to see all the stored libraries.

This is the 48GX, but the same applies for 49g, 50g, etc.

--Bob Prosperi
Find all posts by this user
Quote this message in a reply
10-31-2021, 02:01 PM (This post was last modified: 10-31-2021 02:03 PM by dwesti.)
Post: #6
RE: how to open *.DIR?
thanks, it works
for Ripplev3 (https://www.hpcalc.org/details/8965)
I see Graphic 131x64, but I don't know how to display pictures

UPD: put 1 on stack, press [PICTURE]
Find all posts by this user
Quote this message in a reply
11-02-2021, 09:02 PM
Post: #7
RE: how to open *.DIR?
Hello!

Take a look at:
https://area48.com/hp50/dirs.php

Carlos - Brazil
Time Zone: GMT -3
http://area48.com
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)