Search
Member List
Calendar
Help
|
Printing from the HP_50g
|
|
06-04-2021, 08:17 PM
Post: #1
|
|||
|
|||
|
Printing from the HP_50g
Hi all,
It has bothered me for a long time: printing GROB's on the HP 82240B from the HP-50g is extremely slow compared to the HP-48G(X). This applies to both the PR1 and PRLCD command. The GROBs themselves print well, but it's so damn slow. I've looked at the system RPL code of the PR1 command, but other than pointers that have moved, the code is identical. Does anyone know of a trick to make printing much faster? Sincerely, Karel. I use HP-16C, WP-34S emulator, HP-35s, HP-48GX, HP-50g, and HP Prime G2. |
|||
|
|
06-04-2021, 10:28 PM
Post: #2
|
|||
|
|||
|
RE: Printing from the HP_50g
I'm not sure if it applies to graphics, but it might be worth checking the DELAY parameter to see if it's set too high?
|
|||
|
|
|
06-05-2021, 08:47 PM
(This post was last modified: 06-05-2021 08:49 PM by cahlucas.)
Post: #3
|
|||
|
|||
|
RE: Printing from the HP_50g
Dear Bob,
The delay parameter is set to 1.8, so it can't be that. It's only the GROB's that print very slowly, the rest of the objects print at a good speed. So it must be something else, and maybe there is a method to solve this problem. Hopefully, someone knows a solution and is willing to share it. I hope for a reply. Sincerely, Karel. I use HP-16C, WP-34S emulator, HP-35s, HP-48GX, HP-50g, and HP Prime G2. |
|||
|
|
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)