Post Reply 
10C Repair
05-11-2021, 06:22 PM
Post: #1
10C Repair
I have two 10Cs that are acting up.

The first one is fine until I fill the screen with numbers and then various segments across the screen fade.

The second one shows a brief PR Error when I put in batteries, but it quickly fades to nothing.

Both machines were working the last time I used them (10 or so years ago), but one would dim the LCD slightly when I pressed a key.

Does anyone have any info or links on repairing these issues?
Find all posts by this user
Quote this message in a reply
05-11-2021, 08:34 PM
Post: #2
RE: 10C Repair
(05-11-2021 06:22 PM)mmcgaha Wrote:  I have two 10Cs that are acting up.

The first one is fine until I fill the screen with numbers and then various segments across the screen fade.

The second one shows a brief PR Error when I put in batteries, but it quickly fades to nothing.

Both machines were working the last time I used them (10 or so years ago), but one would dim the LCD slightly when I pressed a key.

Does anyone have any info or links on repairing these issues?

Off hand, it seems like a power supply issue, most likely caused by corrosion somewhere, but may be a faulty component inside. An internal inspection should find the corrosion or wiggling the board(s) to see if a connector is playing up.

If the main chip is faulty, I don't know how available they are and if they can be replaced.

cheers

Tony
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)