Post Reply 
HP 67/97 Card Reader
04-30-2021, 04:46 PM
Post: #1
HP 67/97 Card Reader
There are 4 nylon ball / reed switches used to control these card readers. 3 are identified - motor, heads, write protect. What is the 4th one for??

Thanks and Regards,

Dave
Visit this user's website Find all posts by this user
Quote this message in a reply
04-30-2021, 11:44 PM (This post was last modified: 04-30-2021 11:57 PM by teenix.)
Post: #2
RE: HP 67/97 Card Reader
(04-30-2021 04:46 PM)Dreato Wrote:  There are 4 nylon ball / reed switches used to control these card readers. 3 are identified - motor, heads, write protect. What is the 4th one for??

Thanks and Regards,

Dave

The circuit layout on the May74 Journal Fig5 Page 6, shows a 4th switch as a motor inhibit, but I guess they decided they didn't need it. This was probably connected to the MI pin on the sense chip, which is tied to the switched battery voltage, so the motor is uninhibited. Same issues for the 67. The 97 looks like the MI pin has a delay before being switched high. Maybe the motor started briefly at turn on without it.

The circuit board pad that this 4th contact finger connects to goes nowhere so I guess now it is a spare part after you lose one of the others.

cheers

Tony
Find all posts by this user
Quote this message in a reply
05-01-2021, 12:10 AM
Post: #3
RE: HP 67/97 Card Reader
Thanks, Tony. Good information! You've relieved me of some of my ignorance.

Regards,

Dave
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)