Post Reply 
(SR-56) Inductor calculation program
05-13-2020, 11:41 AM
Post: #1
(SR-56) Inductor calculation program
An excerpt from Tanks a Lot! … inductor calculation program, 73 magazine, December 1977, pgs. 182-183

" … The program shown here carries out the above procedure starting b at .05 and incrementing it by .05 units after each calculation and comparison until the difference between tpi times length and turns changes sign, that is, crosses zero. Then it decrements b by .001 units and continues in the same fashion until the sign changes again, whereupon it stops and displays the number of turns. The result is, for all practical purposes, excellent. One must initiate the program by putting the various parameters in the memory registers, all ten of which are used with my SR-56"

BEST!
SlideRule
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)