Post Reply 
SOL_BG and the New Update
05-29-2014, 09:51 AM
Post: #1
SOL_BG and the New Update
Since updating my firmware I can't run the SOL_BG program. I looked at it and still can't figure out why. Has anyone been able to make this excellent solitaire program run on the new version?

Tom L
Cui bono?
Find all posts by this user
Quote this message in a reply
05-29-2014, 01:47 PM (This post was last modified: 05-29-2014 01:50 PM by Tim Wessman.)
Post: #2
RE: SOL_BG and the New Update
Hello,

There are 4 changes required (at least, it runs and seems to work with my 30s of checking). With the source on your unit, open it and in the editor press CHECK and you'll be taken to the first one. There is an extra END that shouldn't be there, then CHECK again to see the sigmaLIST. The sigma character needs to be changed to the correct one (it can be found in the shift-9 pop up). There are 3 of those.

Once that is done, it works fine. If that seems like too much work, just drag and drop this zip file onto your calculator in the conn kit and it will send it.

[attachment=717]

TW

Although I work for HP, the views and opinions I post here are my own.
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)