Post Reply 
Sum Bug
04-29-2019, 11:19 PM
Post: #1
Sum Bug
Hi there, I was trying Sum(x^2, x=0 to 100,000) in the Cas mode but the calculator restarts. Am I doing something wrong? It works well in home mode as well in a Ti Nspire CAS. Hopefully it is a simple bug to be fixed in the next firmware release. Thanks
Find all posts by this user
Quote this message in a reply
04-30-2019, 01:05 AM
Post: #2
RE: Sum Bug
Just tested on what I think is the latest public with a Prime G1 and worked fine. Anyone else?

TW

Although I work for HP, the views and opinions I post here are my own.
Find all posts by this user
Quote this message in a reply
04-30-2019, 02:26 AM
Post: #3
RE: Sum Bug
(04-30-2019 01:05 AM)Tim Wessman Wrote:  Just tested on what I think is the latest public with a Prime G1 and worked fine. Anyone else?

It SEEMS to hang on a rev C hardware running firmware rev 12214 (2017 08 03), but it actually finishes correctly after 24 seconds. On a rev C hardware running firmware rev 14055 (2018 09 07), it finishes almost instantly. HW rev D *does* finish instantly.

Eduardo: What is your Prime's firmware version?

<0|ΙΈ|0>
-Joe-
Visit this user's website Find all posts by this user
Quote this message in a reply
04-30-2019, 03:21 AM
Post: #4
RE: Sum Bug
(04-30-2019 01:05 AM)Tim Wessman Wrote:  Just tested on what I think is the latest public with a Prime G1 and worked fine. Anyone else?

On my G2 it gives an answer immediately.

Tom L

Tom L
Cui bono?
Find all posts by this user
Quote this message in a reply
04-30-2019, 11:45 AM
Post: #5
RE: Sum Bug
Thanks so much, fixed after updating to the latest firmware.
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)