Post Reply 
HP41 keyboard overlay model for 3d printer
11-14-2018, 10:51 AM
Post: #1
HP41 keyboard overlay model for 3d printer
Hello

I have designed a keyboard overlay model for a HP41 calculator:

https://www.thingiverse.com/thing:3215428
Find all posts by this user
Quote this message in a reply
11-14-2018, 03:17 PM
Post: #2
RE: HP41 keyboard overlay model for 3d printer
(11-14-2018 10:51 AM)Astro3D Wrote:  Hello

I have designed a keyboard overlay model for a HP41 calculator:

https://www.thingiverse.com/thing:3215428

Neat! Have you made any yet? How does the thickness compare to the original?
Find all posts by this user
Quote this message in a reply
11-14-2018, 03:24 PM
Post: #3
RE: HP41 keyboard overlay model for 3d printer
With a couple very minor tweaks to the layout, you can make it reversible, so both sides can be used.

Required mods:

1. Remove the vertical bar between the 2 rightmost holes in the 4th row down.

2. Slightly enlarge the horizontal width on the right edge of the leftmost 3 columns of the bottom 4 rows. Though not apparent with casual use, it is easily seen (just turn one over to check fit) that the number keys are not spaced uniformly due to the larger size of the digit keys.

--Bob Prosperi
Find all posts by this user
Quote this message in a reply
11-14-2018, 05:15 PM (This post was last modified: 11-14-2018 11:09 PM by Astro3D.)
Post: #4
RE: HP41 keyboard overlay model for 3d printer
(11-14-2018 03:17 PM)burkhard Wrote:  Neat! Have you made any yet? How does the thickness compare to the original?

Yes, I made it: You have a couple of pictures in thingsverse: https://www.thingiverse.com/thing:3215428 and I enclosed one picture here.

(11-14-2018 03:17 PM)burkhard Wrote:  Neat! Have you made any yet? How does the thickness compare to the original?

The thickness is something bigger than the original but the fit in the calculator is great !!!


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
11-15-2018, 10:22 AM
Post: #5
RE: HP41 keyboard overlay model for 3d printer
Nice! But how do you label it?
Find all posts by this user
Quote this message in a reply
11-15-2018, 11:21 AM
Post: #6
RE: HP41 keyboard overlay model for 3d printer
(11-15-2018 10:22 AM)Harald Wrote:  Nice! But how do you label it?

I use adhesive labels. I think you could also use a permanent marker
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)