(41CV) Pipe Bending Computations

10072018, 10:24 PM
(This post was last modified: 08042019 01:31 PM by SlideRule.)
Post: #1




(41CV) Pipe Bending Computations
An extract (pgs. 4146) from;
Pipeline Rules of Thumb Handbook handbook: quick and accurate solutions to your everyday pipeline problems W.E. McAllister, editorâ€”5th ed Rev. ed. of: Pipe line rules of thumb handbook. 4th ed. 1998 Gulf Professional Publishing: Pipe bending computations made with handheld calculator "The following program (Table 1), written for the Hewlett Packard 41C/CV calculator, addresses the geometry of fabricating offset bends, sloping scraper traps, connections and direction changes common to all pipelines. Minimum code radii are calculated for each size of oil or gas line. The vertical distance between below and above ground center lines is matched to a design distance with given tangents (5 ft is a convenient tangent for pipe bending machines). The bend angle, overall horizontal distance, and total length of pipe are calculated for each configuration." BEST! SlideRule #1 of 7 

10082018, 07:08 AM
(This post was last modified: 03022019 12:00 PM by StephenG1CMZ.)
Post: #2




RE: (41) Pipe Bending Computations
When I try to open that, I get "Attachment.php is of the incorrect format" .(Android)
Update: It seems my Android may have been "improved" again. Perhaps one day a portable document format will be invented. Stephen Lewkowicz (G1CMZ) 

10082018, 07:19 AM
Post: #3




RE: (41) Pipe Bending Computations  
10122018, 04:44 PM
Post: #4




RE: (41) Pipe Bending Computations  
08042019, 04:07 PM
Post: #5




RE: (41CV) Pipe Bending Computations
repost w/ new LINK (see #1)
SlideRule 

« Next Oldest  Next Newest »

User(s) browsing this thread: 1 Guest(s)