Post Reply 
Saving the state of HP41 CL to PC
03-08-2019, 08:28 AM
Post: #23
RE: Saving the state of HP41 CL to PC
(03-08-2019 06:19 AM)Ángel Martin Wrote:  
(03-08-2019 03:41 AM)cdmackay Wrote:  Edit: or better to use the V5 top sector that is segmented, and change YWALL to use flash pages 0x3f8/0x3fc to copy RAM 0x800/0x804?

I think both your proposals will work just fine. But wouldn't you mean using 0x3FE and 0x3FF atop of V5? - tha'd follow the same analogy.

I'd like to make it a bit more general-purpose though and add some logic to determine first whether it's a V5 board or not, so it can be used by all users...

thanks Ángel.

Yes, of course, you're right. I was trying to preserve the page spacing, in case the need arose to also copy 0x801/802/803. But the original YWALL doesn't do that either, so forget it.

Right, the official YWALL needs to work for all boards, of course. I was wondering about making my own copy of it (although can I do that?) and edit it just to suit my V5 board, in the meantime.

thanks again!

Cambridge, UK
41CL/DM41X 12/15C/16C DM15/16 71B 17B/BII/bII+ 28S 42S/DM42 32SII 48GX 50g 35s 30b/WP34S Prime G2
& Casios, Rockwell 18R :)
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
Saving the state of HP41 CL to PC - PeterP - 12-27-2017, 11:30 PM
RE: Saving the state of HP41 CL to PC - cdmackay - 03-08-2019 08:28 AM

User(s) browsing this thread: 1 Guest(s)