MOD, ODD() in Program

[Han]

(03-27-2014 08:21 AM)Angus Wrote:  That makes sense. I just wonder if I should or could have known that before. I have searched the command list and the handbook again and I must state I still don't get a better understanding. I even did not find e.g operator/command limitations mentioned anywhere.
So to sum it up: a program is interpreted as if the calculator is in home mode? Why does a program compile the int() command at all if not coded as CAS.int() ?

Knowledge of this behavior depends on whether you are familiar with the HP39GII and/or xcas/giac. At any rate, you can always get useful information about command syntax via Help. Press the toolbox button, select the catalog of commands, and find your command int among the list (you can just tap [TAN] [()] [/] really quickly to get there) and press the help button. Maybe a future firmware update will allow the [Help] button to pull up the help info by simply placing the cursor in the command line on the command of interest. Keep your fingers crossed.