Post Reply 
41CL - PowerCL Extreme - Problems (probably operator related)
12-18-2017, 05:53 AM (This post was last modified: 12-18-2017 06:05 AM by Ángel Martin.)
Post: #7
RE: 41CL - PowerCL Extreme - Problems (probably operator related)
Bob has already mentioned the OSX3 as the ROM mnemonic for the most capable version of the AMC_OS/X

Also important is to use YFNX - and not YFNS - with the PowerCL Extreme PRWX.
These two need to be paired, as mentioned in the manual a few times...

BTW on the CL the Hepax ROM does not relocate automatically to the lowest available page, you need to specify which page to plug it to in the PLUG command, or using any of the HEPX4/8/16 utilities (these also load and configure the Hepax RAM).

Finally, the latest revision of PWRX returns
Quote:REV: 07.21.2017

So you're not using the latest and this may account for the fact that the PWRX page is not shown in the BANKED results (I vaguely remember I had to tweak it when the code was moved to bank-3). But this is just a cosmetic glitch in the reporting; the module is bank-switched I assure you that... and should be otherwise fully operational.

Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: 41CL - PowerCL Extreme - Problems (probably operator related) - Ángel Martin - 12-18-2017 05:53 AM

User(s) browsing this thread: 1 Guest(s)