newRPL - build 1255 released! [updated to 1299]
|
12-23-2017, 11:38 PM
(This post was last modified: 12-23-2017 11:40 PM by Claudio L..)
Post: #31
|
|||
|
|||
RE: newRPL - build 1001 released!
(12-23-2017 05:06 PM)Gilles59 Wrote: Hello, Same as in the calc, to break out of a program you use On+A+C, on the PC you have to press ESC+A+C. Now ESC sometimes gets taken by Windows (very annoying) and stops working, so I also mapped the key Home to On, therefore Home+A+C should work. Keep in mind the simulator doesn't respond well to single key touches while the exception handler is running (I have no clue why, everywhere else the keyboard works fine), so once you get the Cont/Exit/Warmstart/Reset options, just press and hold B (Exit) for a few seconds until it works, it should stop and show an error message "Aborting RPL engine". The On key by itself is too dangerous, it is too easy to accidentally stop a calculation in the middle. EDIT: Sorry, forgot your last question: If you type MEM on the simulator, you'll see more than 1.1 MB free. I defined relatively small because that way there's more GC's and it helps me debug, as it crashes a lot more! |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 2 Guest(s)