Post Reply 
Weird behavior HP41c
10-02-2017, 04:52 PM (This post was last modified: 10-02-2017 06:29 PM by Neve.)
Post: #10
RE: Weird behavior HP41c
(10-02-2017 04:45 PM)Geoff Quickfall Wrote:  Does it only happen when the quad is in place? Is the calc stable without the quad in place?

To be honest, I haven’t tried.

(10-02-2017 04:45 PM)Geoff Quickfall Wrote:  If so maybe a contact problem on the module. Ensure contact springs in module (visible) are not deformed. Perhaps an intermittent contact causing the partition to corrupt when calc is jiggled.

I have placed a drop of DeOxit gold or Red on the contacts of the module then plug and unplug a few times.

I’ll check that and use some contact cleaner if needed.

Thank You (Again...!) Wink

Engineer & Senior IT Executive
2x HP41CL, HP41CX, HP48GX, HP50g, 2x82162A Printer, 2x82143A Printer, 2x HP-IL, 2x Card-Readers, PIL-BOX.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Weird behavior HP41c - Neve - 10-02-2017, 05:54 AM
RE: Weird behavior HP41c - Geoff Quickfall - 10-02-2017, 06:15 AM
RE: Weird behavior HP41c - Neve - 10-02-2017, 06:22 AM
RE: Weird behavior HP41c - Geoff Quickfall - 10-02-2017, 06:55 AM
RE: Weird behavior HP41c - Neve - 10-02-2017, 07:42 AM
RE: Weird behavior HP41c - Neve - 10-03-2017, 06:29 AM
RE: Weird behavior HP41c - Neve - 10-02-2017, 02:04 PM
RE: Weird behavior HP41c - Geoff Quickfall - 10-02-2017, 03:51 PM
RE: Weird behavior HP41c - Neve - 10-02-2017, 04:38 PM
RE: Weird behavior HP41c - Geoff Quickfall - 10-02-2017, 04:45 PM
RE: Weird behavior HP41c - Neve - 10-02-2017 04:52 PM



User(s) browsing this thread: 1 Guest(s)