Post Reply 
NumWorks open source calculator
07-10-2018, 08:47 PM (This post was last modified: 07-10-2018 08:48 PM by Jean-Baptiste Boric.)
Post: #70
RE: NumWorks open source calculator
(07-10-2018 08:11 PM)Claudio L. Wrote:  
(07-10-2018 05:30 PM)Jean-Baptiste Boric Wrote:  * Well, technically my HP Prime port uses software floating point and does not take advantage of the FPU in the S3C2416, but raw integer performance is mostly tied.

As far as I know, there's no FPU on the S3C2416.

The S3C2416 has an ARM926EJ core. I'm fairly sure it has VFP since HP's own firmware has lots of VFP instructions inside armfir.elf (well, they could trap and fallback to softfp emulation, but I do hope they haven't done something that backwards). It's just that by the time PRIME_OS.ROM runs, VFP hasn't been enabled yet and I was not in the mood to meddle with black magic processor state.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
NumWorks open source calculator - BobVA - 08-28-2017, 10:33 PM
RE: NumWorks open source calculator - Dan - 08-29-2017, 02:37 AM
NumWorks User manual!!!!!!!!!! - Namir - 09-06-2017, 08:10 PM
RE: NumWorks open source calculator - JDW - 07-07-2018, 10:30 PM
RE: NumWorks open source calculator - JDW - 07-08-2018, 12:55 PM
RE: NumWorks open source calculator - JDW - 07-09-2018, 12:03 AM
RE: NumWorks open source calculator - JDW - 07-10-2018, 12:04 AM
RE: NumWorks open source calculator - Jean-Baptiste Boric - 07-10-2018 08:47 PM
RE: NumWorks open source calculator - JDW - 07-15-2018, 01:11 PM
RE: NumWorks open source calculator - JDW - 07-12-2018, 12:03 AM
RE: NumWorks open source calculator - JDW - 07-14-2018, 01:41 PM



User(s) browsing this thread: 1 Guest(s)