HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / Existing CAS commands --> Prime discussion

Post Reply 
Existing CAS commands --> Prime discussion
12-11-2018, 03:49 AM
Post: #53
Joe Horn Offline
Senior Member
 		Posts: 1,998
Joined: Dec 2013
RE: Existing CAS commands --> Prime discussion
(12-10-2018 05:45 AM)John P Wrote:  
(12-10-2018 01:43 AM)Joe Horn Wrote:  It was never included in Prime's vocabulary.

Probably not, but I think I used it after reading, a while ago, the cascmd_en. Now when I type makevector(1,2,3) nothing happens on my HP Prime with the latest firmware. Maybe you have different one.

Although I meant that no version of the HP Prime firmware, ever, has had a 'makevector' command (I checked a bunch of versions, from beta versions before Prime was even announced, through the most recent version, including my 8 Primes which have different official firmware versions installed in each), it is possible that 'makevector' was introduced at some point and then removed again in a subsequent firmware version. Although I wouldn't bet on that, I'd be happy to be proven wrong.
<0|ΙΈ|0>
-Joe-
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Existing CAS commands --> Prime discussion - Joe Horn - 12-11-2018 03:49 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication