Post Reply 
41CL chips going EOL - how many 41CL boards are desired in the future ?
06-15-2017, 08:42 PM
Post: #8
RE: 41CL chips going EOL - how many 41CL boards are desired in the future ?
(06-15-2017 06:24 PM)Sylvain Cote Wrote:  
(06-15-2017 06:09 PM)Monte Dalrymple Wrote:  At the same time, I am also considering finally doing an assembly run for the clone of the Time module.

How this assembly will be packaged ?
in a plug in module or as a daughter board on the CL ?
If it is a daughter board, what will be the compatibility with the beta, v2, v3, v4 & v5 boards ?

Best regards,

Sylvain

Either way. The board is designed to go into a module housing, but you can always solder it internally. Only V4 and V5 boards have connection points on the top of the board for this purpose, but you can always solder it directly to the 41C bus up by the display drivers. I would not recommend trying to solder it to the 41CL board directly unless you are an experienced solderer and have a temperature-controlled small-tip soldering iron. The connection points are only 1mm x 1mm on the CL board, so it will likely require 30-guage wire and a steady hand.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: 41CL chips going EOL - how many 41CL boards are desired in the future ? - Monte Dalrymple - 06-15-2017 08:42 PM



User(s) browsing this thread: 2 Guest(s)