Post Reply 
Please help me understand
03-02-2014, 05:23 PM (This post was last modified: 03-02-2014 05:28 PM by DrD.)
Post: #5
RE: Please help me understand
I had the original program (dmy) left in the shift 1 catalog. I was not seeing the dmy(CAS) entry that I had put in via the CAS command line. So I deleted the original program, and now I do see the CAS entry version. Maybe there is a conflict if the same program name is resident in both environments? Maybe just a lot of learning (on my part) better explains it. In any event, I had not read about this distinction in the documentation so far.

Thanks for that link, it sheds more light on the subject.

I just noticed that the dmy(CAS) program does not show up in the connectivity kit, even after restarting both the ck and the virtual calc. It is present on the virtual calc, though. So editing via the ck editor is still an issue.

-Dale-

I have just edited my post. I realized that once we define a small CAS program from the command entry line, we can see it from the general listing of programs (Shift+1), so it should be possible to edited it in the usual way.
Pls see: http://www.hpmuseum.org/forum/thread-683...s+function
[/quote]
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Please help me understand - DrD - 03-02-2014, 01:07 PM
RE: Please help me understand - parisse - 03-02-2014, 03:56 PM
RE: Please help me understand - DrD - 03-02-2014, 04:22 PM
RE: Please help me understand - jebem - 03-02-2014, 04:41 PM
RE: Please help me understand - DrD - 03-02-2014 05:23 PM
RE: Please help me understand - jebem - 03-02-2014, 05:33 PM
RE: Please help me understand - DrD - 03-02-2014, 05:45 PM



User(s) browsing this thread: 1 Guest(s)