A replacement for the HP-41 zebra connector

[mfleming]

(04-05-2017 11:35 PM)Dave Frederickson Wrote:  From the pic you can see that the connector is about 0.7" long, 0.15" wide, and as I mentioned, about 0.4" high. The housing and polymer core can be salvaged, so all that's needed is a thin flex like this:

Looks easy enough. Could you provide overall flex dimensions, contact width, pitch, and number? Perhaps a pic of one, stretched out for view? The housing and core of the HP-71 connector sounds an awful lot like a general solution for the HP-41 (two needed?) Perhaps save the idea for iteration #2 if there is enough interest in this current solution.

~Mark