Post Reply 
Little explorations with HP calculators (no Prime)
03-21-2018, 11:27 PM
Post: #287
RE: Little explorations with HP calculators (no Prime)
(03-21-2018 08:37 PM)pier4r Wrote:  So it is the first time (or maybe not, but I do not remember the previous time, if there was one) I connected two hp 50g to my win XP thinclient.

The problem is, if I connect with the connectivity kit to one system, then I disconnect and I try to connect to the other, it doesn't work.

Procedure.
hp 50g A , Xm server activated
conn4x, connect
it works.
conn4x disconnect (it stops the server on the 50g A)
hp50g B, Xm server activated
conn4x connect
problems
hp50g B, Xm server deactivated
hp50g A, Xm server activated
conn4x connect
it works.

If I reset the usb hub (I disconnect it for a while) and then I connect first the hp 50g B, it is the same result, only the 50g B works, not the 50gA.

The 50g-s are connected to the same usb hub, that is connected to one usb port on the system.

How do I get the second 50g working? This because I want to test something and I need parallel execution to make it a bit faster (plus, even having pretty distinct sequences of RAND).

What does "Xm server activated" mean?

In you upper list, the sequence says that hp5g A connect and B does not, but just below that, you summarize "only the 50g B works, not the 50gA".

Which is correct? It's hard to follow the exact steps and results.

You are not trying to connect 2 50g machines to 2 instances of conn4x simultaneously are you?

--Bob Prosperi
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Little explorations with HP calculators (no Prime) - rprosperi - 03-21-2018 11:27 PM



User(s) browsing this thread: 1 Guest(s)