Post Reply 
fighting with a HP41c
01-04-2017, 10:23 PM (This post was last modified: 01-05-2017 07:19 AM by aurelio.)
Post: #8
RE: fighting with a HP41c
(01-04-2017 05:51 PM)AndiGer Wrote:  As it is a tall key 41c I assume made in USA.
So there should be the golden balls at the tunnel to the battery pack.
Did you check the connection from the IO block to these balls?
Outer left to upper ball 0 ohm, outer right + of DMM and lower ball - about 1000 ohm.
If not there is a contact problem between IO block and keyboard PCB.
Wish you success
Andi

not considering the accuracy of my multimeter

I found 0 oms for the first an 78 ohm for the second
and on another tall key got 0 and 39 ohm....
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
fighting with a HP41c - aurelio - 01-01-2017, 06:46 PM
RE: fighting with a HP41c - Brad Barton - 01-03-2017, 02:01 PM
RE: fighting with a HP41c - aurelio - 01-03-2017, 08:23 PM
RE: fighting with a HP41c - d b - 01-03-2017, 10:02 PM
RE: fighting with a HP41c - aurelio - 01-03-2017, 10:46 PM
RE: fighting with a HP41c - aurelio - 01-04-2017, 10:26 PM
RE: fighting with a HP41c - AndiGer - 01-04-2017, 05:51 PM
RE: fighting with a HP41c - aurelio - 01-04-2017 10:23 PM
RE: fighting with a HP41c - AndiGer - 01-05-2017, 08:26 PM



User(s) browsing this thread: 1 Guest(s)