Post Reply 
HP Restoration
12-12-2016, 09:59 PM (This post was last modified: 12-12-2016 10:02 PM by Geoff Quickfall.)
Post: #17
RE: HP Restoration
If you are talking about the heatstakes then yes, remelting is possible if enough of the heat stake was left. I use a solder iron to mushroom the remaining stake and add glue.

Others have used TINY screws!

Geoff

Silver leaf pen and etc. do wear on surfaces exposed to wear. The badge when slipped into the calculator sleeve or when sitting upside down on the desk will wear. It is proud of the bezel surface.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP Restoration - coerrace - 12-11-2016, 01:35 AM
RE: HP Restoration - Geoff Quickfall - 12-11-2016, 06:37 AM
RE: HP Restoration - Massimo Gnerucci - 12-11-2016, 08:44 AM
RE: HP Restoration - aurelio - 12-11-2016, 11:29 AM
RE: HP Restoration - Geoff Quickfall - 12-11-2016, 09:17 AM
RE: HP Restoration - PANAMATIK - 12-11-2016, 10:19 AM
RE: HP Restoration - Massimo Gnerucci - 12-11-2016, 12:27 PM
RE: HP Restoration - aurelio - 12-11-2016, 12:55 PM
RE: HP Restoration - coerrace - 12-11-2016, 02:49 PM
RE: HP Restoration - aurelio - 12-11-2016, 04:03 PM
RE: HP Restoration - coerrace - 12-11-2016, 04:08 PM
RE: HP Restoration - Geoff Quickfall - 12-12-2016, 06:04 PM
RE: HP Restoration - Didier Lachieze - 12-12-2016, 07:56 PM
RE: HP Restoration - coerrace - 12-12-2016, 08:13 PM
RE: HP Restoration - Didier Lachieze - 12-12-2016, 08:33 PM
RE: HP Restoration - Vtile - 12-12-2016, 09:54 PM
RE: HP Restoration - Geoff Quickfall - 12-12-2016 09:59 PM
RE: HP Restoration - anetzer - 12-13-2016, 05:38 AM
RE: HP Restoration - Geoff Quickfall - 12-13-2016, 06:37 AM
RE: HP Restoration - Massimo Gnerucci - 12-13-2016, 06:57 AM



User(s) browsing this thread: 1 Guest(s)