DM41L serial transfer help!

[Geoff Quickfall]

Haven't done much with terminal communications for awhile.

Here is the problem: I want to save the calculator state (13 routines at over 1300 registers and extended memory data files).

I followed Swiss micros instructions at the web site:

Downloaded Putty (win10). Successful
Downloaded UART USB driver. Successful
Configured serial in Putty as per instructions.

Configured the 41 "SERIAL CONSOLE"
Attached cable from 41 to USB on computer.

Now what? clicking done in PUTTY chimes, where is the consol to read the dump...?

I am a real newbie here to putty, but it can't be any more difficult then the 15 34s I have created, or the 4 41cls, Clonix, novram ...

So if you have a step by step guide knowing I have Putty, driver installed and can use the UART to USB cable.

Help


I am doing this so I can save all the work I did manually to configure the 41 for work BEFORE I start playing with synthetics and creating the LB (load bytes) program.

Cheers, Geoff