Post Reply 
Is the 12C SDK still available?
11-22-2015, 11:36 AM
Post: #16
RE: Is the 12C SDK still available?
(11-22-2015 06:31 AM)Katie Wasserman Wrote:  note that +5 volt from USB is not connected.
So the port is meant to be used for flashing only. For transfer of data/programs at runtime, the VBUS signal would be needed so the calculator can reliably detect that it gets connected to a host - but that would require modifications to the original 12C firmware image anyway - well, assuming this new version of the HP 12C is based on an adapted version of the Nut emulator and not running a functional reimplementation of the 12C natively.

Quote:The version with the SAM4L chip was likely released sometime earlier this year, maybe in the March/April time frame.
This would fit in nicely with my observation that the 12C (but not the 12c Platinum) was out of supply in several of the larger calculator online shops over here for some while earlier this year.

Does the new version come with one or two CR2032 cells? Are there other differences in the labelling on the calculator (except for the serial number) or the package to reliably distinguish this from the older version pre-purchase?

Greetings,

Matthias


--
"Programs are poems for computers."
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Is the 12C SDK still available? - emece67 - 11-20-2015, 09:59 PM
RE: Is the 12C SDK still available? - matthiaspaul - 11-22-2015 11:36 AM
RE: Is the 12C SDK still available? - d b - 11-25-2015, 11:52 PM
RE: Is the 12C SDK still available? - Dol - 09-06-2016, 07:11 PM



User(s) browsing this thread: 1 Guest(s)