HP32E Repairing
|
11-14-2016, 03:10 PM
Post: #6
|
|||
|
|||
RE: HP32E Repairing
(11-13-2016 08:51 PM)ElectroDuende Wrote: No, I'm afraid that all Spices that I had lately monitored on Ebay have finished too much expensive for me (even defective models). I'll keep on waiting... Thanks for your reply. Concerning the LED display, I was curious where it can be repaired. Assuming the issue is a broken bond wire (as per Kees description), a new thin wire could be soldered to the pcb and then just bent to make contact with the led segment; a small drop of conductive paint would fix it. Of course this would require a magnifying system. You know that these led segments can be tested in the usual way with just a multi-meter set to diode testing (I tested my LED display in this way using a Protek 505 which presents 2.9V in open connection). Meanwhile I found the answer for my LED display power supply question. As you said, it is regulated from the DC-DC converter (Kees has published power supply schematics here). Jose Mesquita RadioMuseum.org member |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HP32E Repairing - ElectroDuende - 10-11-2015, 11:03 PM
RE: HP32E Repairing - ElectroDuende - 10-12-2015, 02:00 AM
RE: HP32E Repairing - Harald - 10-12-2015, 07:24 AM
RE: HP32E Repairing - jebem - 11-10-2016, 02:18 PM
RE: HP32E Repairing - ElectroDuende - 11-13-2016, 08:51 PM
RE: HP32E Repairing - jebem - 11-14-2016 03:10 PM
RE: HP32E Repairing - ElectroDuende - 11-14-2016, 09:50 PM
|
User(s) browsing this thread: 1 Guest(s)