Post Reply 
[WP 34s] reference card
01-17-2014, 03:04 AM (This post was last modified: 01-17-2014 03:09 AM by nsg.)
Post: #4
RE: [WP 34s] reference card
(01-16-2014 07:35 AM)walter b Wrote:  [*]LOADSS doesn't belong to stack but to system status (I'd put it next to SAVE instead).
Walter, what exactly is LOADSS doing? It does not look like it is explained in the manual, just says "restores system state". What is "system state" in this context? In case it restores only "config" area, would it be more appropriate to group with STOM and RCLM?

Quote:[*]Special registers start with X.
Could you expand on that? I used the words "special register" loosely, meaning they are not stack registers, that is are not moved around by operations and stack commands.

(01-16-2014 08:58 PM)Dieter Wrote:  Please take a look at the PROB section. Are you sure the parameters in J and K did not get swapped? The left column should be J and the right one K.
Yes, thank you. It looks like the columns should be swapped. Probably the artuifact of earlier edition when the register list was to the left of PROB parameters.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[WP 34s] reference card - nsg - 01-16-2014, 01:24 AM
RE: [WP 34s] reference card - walter b - 01-16-2014, 07:35 AM
RE: [WP 34s] reference card - nsg - 01-17-2014 03:04 AM
RE: [WP 34s] reference card - walter b - 01-17-2014, 05:15 AM
RE: [WP 34s] reference card - Dieter - 01-16-2014, 08:58 PM
RE: [WP 34s] reference card - nsg - 01-22-2014, 12:06 AM
RE: [WP 34s] reference card - nsg - 01-22-2014, 11:18 PM
RE: [WP 34s] reference card - Gene - 01-23-2014, 01:45 PM
RE: [WP 34s] reference card - nsg - 01-30-2014, 02:19 AM
RE: [WP 34s] reference card - walter b - 01-30-2014, 02:39 AM



User(s) browsing this thread: 1 Guest(s)