[WP 34s] Trapezoidal approximation of area under curve

06162015, 10:47 AM
(This post was last modified: 06162015 10:49 AM by Marcio.)
Post: #7




RE: [WP 34s] Trapezoidal approximation of area under curve
Hello again,
Does anyone know how to do \(RCL+ Z\) on the 35s? From what I saw in the manual, one has to use the EQN inside the program in order to recall the \(z\)register, which is somewhat dangerous. Thanks. 

« Next Oldest  Next Newest »

Messages In This Thread 
[WP 34s] Trapezoidal approximation of area under curve  Marcio  06012015, 01:53 PM
RE: [WP 34s] Trapezoidal approximation of area under curve  Marcus von Cube  06012015, 03:54 PM
RE: [WP 34s] Trapezoidal approximation of area under curve  Dave Britten  06012015, 05:36 PM
RE: [WP 34s] Trapezoidal approximation of area under curve  Thomas Klemm  06012015, 06:56 PM
RE: [WP 34s] Trapezoidal approximation of area under curve  Dieter  06022015, 09:23 PM
RE: [WP 34s] Trapezoidal approximation of area under curve  Marcio  06022015, 02:46 AM
RE: [WP 34s] Trapezoidal approximation of area under curve  Marcio  06162015 10:47 AM
RE: [WP 34s] Trapezoidal approximation of area under curve  Dieter  06162015, 11:31 AM
RE: [WP 34s] Trapezoidal approximation of area under curve  Thomas Klemm  06162015, 12:38 PM
RE: [WP 34s] Trapezoidal approximation of area under curve  Marcio  06162015, 12:57 PM

User(s) browsing this thread: 1 Guest(s)