Post Reply 
HP 28s rom dump with 50g
03-23-2015, 01:49 PM (This post was last modified: 03-23-2015 02:07 PM by matthiaspaul.)
Post: #7
RE: HP 28s rom dump with 50g
I have read reports that BINPRT doesn't work on the HP 49g+, so it may not work on the 50g as well. But please try it, so we know for sure.

I may be pointing to the obvious, but one significant difference between the HP 48GX/G+ and the HP 48gII/49g+/50g is that the later only support IrDA, whereas the former only support a proprietary HP SIR protocol. Another difference is the emulation layer.

However, this should only be a problem for BINPRT for as long as the hardware/emulator would provide the received data byte-wise already. If the hardware/emulator allows to log away the raw bit-wise stream of state transitions of the IR receiver itself, it shouldn't matter. Since I have never programmed the IR port on these machines, I do not know the answer to this question, but I'm sure others will. Is the source code to BINPRT available anywhere?

Greetings,

Matthias


--
"Programs are poems for computers."
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP 28s rom dump with 50g - Jlouis - 03-23-2015, 12:50 AM
RE: HP 28s rom dump with 50g - Jlouis - 03-23-2015, 10:45 AM
RE: HP 28s rom dump with 50g - matthiaspaul - 03-23-2015 01:49 PM
RE: HP 28s rom dump with 50g - Jlouis - 03-23-2015, 09:55 PM
RE: HP 28s rom dump with 50g - BartDB - 07-19-2016, 04:23 PM
RE: HP 28s rom dump with 50g - JDW - 07-20-2016, 12:02 AM
RE: HP 28s rom dump with 50g - JDW - 07-20-2016, 01:45 AM
RE: HP 28s rom dump with 50g - JDW - 07-20-2016, 02:39 AM



User(s) browsing this thread: 1 Guest(s)