Post Reply 
HP 82162A repair drive belt
02-01-2015, 04:38 PM
Post: #7
RE: HP 82162A repair drive belt
(01-25-2015 10:55 PM)Jurgen Keller Wrote:  In the referenced post the size was specified as 0.75" (inner diameter) and 0.04" (thickness). Converted to metric units this would be 19 x 1 mm. I guess I've found a source here in Switzerland:
https://shop.maagtechnic.ch/ishop/articl...012697.xml

I've got the o-ring mentioned above, and my printer works again :-) However, the 1mm o-ring seem to be a little bit thinner than the original one. I think the 1.5mm (also available from the source referenced above) would be closer to the original drive belt. See attached picture.


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: HP 82162A repair drive belt - Jurgen Keller - 02-01-2015 04:38 PM



User(s) browsing this thread: 1 Guest(s)