Post Reply 
Oldest computer you've used for "real work"?
03-12-2015, 12:00 AM
Post: #22
RE: Oldest computer you've used for "real work"?
(03-10-2015 02:53 AM)Paul Berger (Canada) Wrote:  Interesting but would not work on a selectric, but a selectric is even easier you just need to sense either the 6 selection latches or the bails under the keyboard that where moved by the combination of the filter shaft and interposer under the key that was struck. On the first I/O mechanism, since it printed every time you struck a key, a block of contacts under the selection mechanism sensed the latches that where not pulled off the selection bail. The later mechanism that had the keyboard disconnected from the printer used the bails under the keyboard to move magnets over a board with reed switches on it. The selection mechanism in the selectric is essentially a mechanical digital to analog converter that converts the latches selected into 11 positions of rotate and 4 positions of tilt to position the desired character for printing. Upper case shift rotates the ball 180 degrees via a separate cam. Its been over 30 years since I worked on one, but in my early days as a service rep I worked on so many selectric terminals, the way they operate is permanently burned into my brain.

The way you describe that sooo makes me want to rig a 'golf ball' up to a couple of stepper motors controlled by an rPi. As you type on the keyboard, the rPi spins the ball and takes a picture of the 'output' character using the camera. Mirror the image and compose the typing as a series of PNGs!!

Bonkers but fun and you could even change the typeface!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Oldest computer you've used for "real work"? - BruceH - 03-12-2015 12:00 AM



User(s) browsing this thread: 1 Guest(s)