Post Reply 
ILPer v1.44 update
09-30-2014, 06:58 PM
Post: #1
ILPer v1.44 update
ILPer has been updated to v1.44 at http://hp.giesselink.com.

Major changes:

Auto-extended address mode

Since ILPer v1.43 both internal devices support the "auto-extended address" mode. This could cause a different device addressing in connection with other "auto-address" devices in the same loop. Also this feature may cause trouble with other forthcoming new features. So in consequence the "auto-extended address" mode was disabled by default in v1.44.

If you want to reactivate this feature you have to modify the registry key value HKCU\Software\EmuTools\Ilper\Settings\AutoExtAddr from 0 to 1 or, when you're using the setup-file method, change the "AutoExtAddr" argument in the "[Settings]" section to 1 please.

Device ID for the mass storage device

Since ILPer v1.44 the device ID of the mass storage simulation changed from ID="HDRIVE1" to ID="HP9114B". This improve compatibility with programs written to access HP9114 floppy disk drives which are using the device ID to identify the device address of attached drives.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
ILPer v1.44 update - Christoph Giesselink - 09-30-2014 06:58 PM
RE: ILPer v1.44 update - rprosperi - 10-01-2014, 12:50 AM
RE: ILPer v1.44 update - Dave Frederickson - 10-01-2014, 02:51 AM
RE: ILPer v1.44 update - Ángel Martin - 10-01-2014, 04:49 AM
RE: ILPer v1.44 update - hp41cx - 10-01-2014, 01:36 PM
RE: ILPer v1.44 update - Sylvain Cote - 10-01-2014, 02:43 AM
RE: ILPer v1.44 update - rprosperi - 10-01-2014, 10:21 PM
RE: ILPer v1.44 update - rprosperi - 10-05-2014, 04:51 PM
RE: ILPer v1.44 update - rprosperi - 10-08-2014, 11:51 PM
RE: ILPer v1.44 update - J-F Garnier - 10-10-2014, 07:02 AM
RE: ILPer v1.44 update - Dave Frederickson - 10-08-2014, 05:33 PM



User(s) browsing this thread: 1 Guest(s)